![]() The M48 accuracy test is also enabled in case you want to test your probe. It will not work if you are using the Z-stop port for the probe. Important: The build assumes you are using the dedicated BL-touch port on the board and you have the Z-stop disconnected. The build enables the offset wizard to simplify the Z-offset measurement. ![]() There are a lot of videos on how to measure and set them. The grid is configured to be symmetrical with 45mm margin on left and right and 15mm on front and back.Īll probe offsets are set to 0. auto_level_7x7_lin base_lin + automatic leveling with 7x7 grid.auto_level_7x7 base + automatic leveling with 7x7 grid.auto_level_5x5_lin base_lin + automatic leveling with 5x5 grid.auto_level_5x5 base + automatic leveling with 5x5 grid.If you have a different type of probe you will need a different configuration. Not sure about the 3D-touch clones, do some research before flashing. Note: Only tested with a CR-touch but a BL-touch should work as well. manual_mesh_7x7_lin base_lin + manual mesh leveling with 7x7 grid.manual_mesh_7x7 base + manual mesh leveling with 7x7 grid.manual_mesh_5x5_lin base_lin + manual mesh leveling with 5x5 grid.manual_mesh_5x5 base + manual mesh leveling with 5x5 grid.There are also numerous videos on youtube. You can read the marlin docs on how to find and set a good value. Better than having a gcode file or moving manually.Īlso enables HOST_ACTION_COMMANDS as required by octoprint. baseīed leveling helper menu to move around the corners. The default Marlin configuration for Ender-3. It's been a while since i used this board.To find out which drivers you have there is a little marking on the sd card slot. All builds here use the default A4988 stepper drivers, you can fork and change that if you have different ones.If your board is the 256K variant you can fork the repo and change the board_env. Some newer models come with 256K of flash. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |